Skip to content
Sewing Techniques

Continuous Lap Placket

Ever wonder how to finish the edge of a slit, like the ones in a sleeve just above a cuff? Well, the Continuous Lap Placket may just be your next best friend! So called because it laps around in one continuous line, this super useful bit of sewing know-how is fabulous for finishing slit edges, while also giving you a place to anchor hooks and eyes or other small closures. 

Start by marking off the length of your slit, and carefully cutting along the line you marked. (If your fabric is delicate or likes to fray, you may want to staystitch about 1/8" away from your marked line on either side, before cutting...)

Cut a strip of fabric at least twice as long as your slit, to be the placket. A 1" wide strip will give you a 1/4" placket, which is great for sleeves, but you'll probably want to cut a much wider strip if you're adding a placket to a skirt. 

Press under one long edge of the strip, 1/4". Pin it along the slit, carefully opening the slit up as you go. The raw edges should line up everywhere BUT at the point -- which is fine and as it should be! The fashion fabric has to dip a bit lower at the point of the slit, to avoid giving you weird puckers. Just make sure that the point doesn't dip down below your stitch line. 

Stitch 1/4" away from the raw edge of the placket fabric. You can see the stitchline pretty clearly in the picture below -- try to just skim across the very point of the fashion fabric, just enough to catch it but not so deep you get puckers. 

Press the placket fabric up, away from the fashion fabric, and fold it over the raw edge. 

Stitch the edge of the placket down, enclosing the raw edges. You can do this by hand or by machine -- I machined it here for clarity, but I think hand-stitching gives the nicest results. :)

As a final step, stitch across the very top of your placket, right at the fold, at a 45 degree angle. This helps reinforce the point of the slit, and gives your placket a nice finished look. Press the placket so that one side folds under, and the other side extends. Congratulations!

Thanks for following along today, everyone! Have fun with this, and let us know in the comments how you use this most fabulous of plackets in your own work!

 

For Pixie Faire,
Melinda

Previous Post Next Post

33 Comments

Cialis 5 Mg Comprime Pellicule Boite De 28 braxygex https://acialisd.com/# – generic cialis vs cialis AppolveAscep Purchase Amoxicillin Without Prescription Canada HokeCeal buy cialis generic online cheap reatutlerm Direct Isotretinoin Where To Order Medication Without Rx West Lothian

п»їcialis

OMG THANK YOU! I’m sewing a children’s dress with the worst instructions imaginable. Their drawing is just nuts. This makes so much more sense!!

Bekah

Best tutorial on internet for doing this. Before finding it, I always screwed it up. Best points are to skim across point of fashion fabric so you don’t get puckers, and to stitch that 45 degree angle to reinforce. Thank you!

Diane

I almost always mess these up!! :(

Tari

This is just what I have been looking for. Thank you for the clear instructions. I am making a child’s dress with an opening at the neckline which was supposed to have a zipper. This will work much better.

Pat Angell

Leave A Comment